The NanoHARD is a multifunction programmable AEG Controller. Thanks to its special coating, it is resistant to atmospheric conditions (Military Specification MIL-V-173C). Battery protection supports: Li-Po 7.4V / 11.1V / 14.8V.

Features

MOSFET

Do you want to achieve a higher rate of fire and faster trigger response? Are you planning a power upgrade of your rifle? In that case, you need a MOSFET.
It targets the energy from the battery directly to the motor, bypassing the mechanical trigger contacts. As a result, you gain a higher rate of fire of the rifle and a faster trigger response, and the contacts are protected against burn out.

Battery Protection

Protection against Over-Discharge of the Battery. Modern LiPo and LiFe batteries are very sensitive to over-discharge. If you do not want to damage the battery and you care about its service life, this protection is indispensable. The microprocessor monitors the battery voltage constantly. When the voltage drops down to a critical level, the Controller will not allow firing.

Debouncing

This provides full compatibility with the micro-switches. It ensures full resistance to contact bounce (vibration). You gain increased ROF, a faster trigger response and your MOSFET is less prone to overheating.

3rd Generation MOSFET

The advent of modern transistors and microcontroller has enabled the creation of the smallest and most reliable AEG Controller on the market.

14.8V LiPo Ready

The system can be used with batteries up to 14.8V LI-PO. Minimum operating voltage is 3V and maximum voltage is 17V.

Coating

Thanks to its special conformal coating, it is resistant to atmospheric conditions (Military Specification MIL-V-173C).

Active Braking

The Controller provides you with the opportunity to decide if you want to use the Active Brake function. If you do not need this, you can turn it off easily to preserve the lifespan of your motor.

Smart Fuse

An electronic fuse with an accurate current sensor, in combination with voltage and temperature measurements protects the MOSFET against overheating, overloading and short-circuiting. In case of a jam, this protects the motor and battery from damage.

Built-in Self-Test

It allows you to quickly check whether the AEG Controller works properly. If you have problems with your AEG, the BUILT-IN SELF-TEST allows you to check that the problem is not caused by the Controller.

Box Contents

• NanoHARD
• Additional kit of Deans-T Connectors
• Single signal wire for trigger contacts
• Double signal wire for trigger contacts
• Programming button
• Jumper (2pcs.)